Pneumatic Press SOP 60144-2

The Pneumatic Press Safe Operating Procedure (SOP)

The Pneumatic Press Safe Operating Procedure (SOP) outlines step-by-step processes for safely operating a Pneumatic Press. A risk assessment form is also included in this pack. 

The Pneumatic Press Safe Operating Procedure SOP Content:

• Management Commitment and Approval
• PPE
• Hazards & Risks
• Precautions
• Pre-Operational Inspection
• Operation Sequence
• On Completion Job Steps

Pneumatic Press Safe Operating Procedure Extract Only

Before using the press, make sure that a shutoff device has been fitted on the air supply line and the location is easily accessible, so that the air supply to the press can be shut off in an emergency.

Punch and anvils:

• Refer to the operations manual (tooling guide) for the appropriate punch and anvil for the fastener being installed
• Disconnect the air supply
• Remove the punch by loosening the (2) set-screws in the ram bushing
• Install the new punch and tighten the (2) set-screws
• Connect the air supply to the press
• Ensure that the foot pedal is connected prior to connecting air supply
• Loosen the set-screw in the side of the anvil holder and remove the anvil
• Install the new anvil into the anvil holder and tighten the set-screw
• Disconnect the air supply to the press
• Check the alignment of the outside diameters of the punch and anvil.

Set up and operation:

1. Set Force to OFF
2. Switch to Set-up Mode
3. Connect Air...

Ready to Use

Save time with our pre-filled, fully customisable templates. Simply add your company details and read the document to ensure all elements are relevant to your business, conduct a risk assessment using the Risk Assessment Form provided and make amendments as required. It is then ready for use as a training tool and as a point of discussion at OHS/WHS/Tool Box Talk meetings.